Specifications¶
Device Specifications¶
Features
Reflection and Transmission Density Measurement for B&W film and paper
Measurement reach sufficient to cover most test strips and material sizes up to 5x7”
Includes calibration reference materials for both reflection and transmission
USB interface for power, measurement logging, and desktop control
Firmware is user upgradable
Measurement Specifications
Operating Specifications
Power source: 5VDC @ 150mA
Can be powered via a standard USB power adapter, or via the USB port of a computer (device connector is compatible with USB-C® 3)
Temperature: 10°-30°C; 50°-86°F
Dimensions: 11cm L x 4.5cm W x 3.5cm H
Weight: 150g
Footnotes
- 1
This claim is based on a combination of response curve of the sensor, properties of the UV-IR cut filter, and the emission spectrum of the light source. These are all off-the-shelf components, and are thus unable to exactly match the response spectrum in the ISO specification. However, they are fairly close, should meet the needs of most use cases involving B&W photographic materials.
- 2
The goal for measurement accuracy is ±0.02D under most circumstances, and ±0.01D under freshly calibrated lab conditions. However, it is difficult to adequately test reflection density beyond 2.00D and transmission density beyond 4.00D due to availability of reference materials.
- 3
USB-C® is a registered trademark of USB Implementers Forum.
Regulatory Information¶
Federal Communications Commission Notice¶
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance Statement¶
CAN ICES-003(B) / NMB-003(B)
CE Declaration¶
Hereby, Dektronics, Inc, declares that the Printalyzer Densitometer DPD-100 has been tested and is fully compliant with the EU EMC Directive 2014/30/EU.
UKCA Declaration¶
Hereby, Dektronics, Inc, declares that the Printalyzer Densitometer DPD-100 has been tested and is fully compliant with the UK EMC Regulations (2016).
Equipment Information¶
Instructions for disposal: Please dispose of Waste Electrical and Electronic Equipment (WEEE) at designated collection points for the recycling of such equipment.
